How To Properly Columbus OH Septic Tank Installation

 Although the companies that sell this equipment usually offer professional installation, you can do it yourself, and thereby save money. Before installing a septic tank, it is necessary to select the power of the equipment of Columbus oh septic tank installation. It depends on the volume of drains. It can be calculated very simply: see the water consumption by the meter. The amount of water will be approximately equal to the amount of effluent. The simplest system is designed to process 1 m 3 per day.

The entire technology of installing a septic tank with your own hands can be conditionally divided into 3 parts:

• Excavation and preparatory work.

• Equipment installation and system check.

• Warming and filling the system with soil.

The procedure for the installation of a septic tank Tank:

Preparatory work consists in drawing up a scheme for Columbus oh septic tank installation with your own hands, choosing a site and selecting pipes and connections. The septic tank can be located in well-drained soils where the water table is not too high.

The septic tank should be located as close to the house as possible, since a large distance between them will require a greater inclination of the pipe, and, accordingly, a greater depth of the septic tank trench.

It is also worth considering the possibility of a car entrance to pump out the sludge formed in the tanks. Although with the proper operation of the system, pumping is carried out no more than 1 time in 2-3 years, there should be free access to the containers. 

Most septic tanks in their work use electricity to operate compressors and circulation pumps. When using these models, it is necessary to provide access of the power cable to the installation site of the equipment.

The pit for installation is dug either manually or using special equipment. Its depth is determined by the parameters of specific equipment. As a rule, manufacturers apply a zero mark on the walls of containers. If the foundation pit is to be dug manually, it is necessary to make a caisson. It will keep the walls of the trench from sliding, which can lead to injury if someone is in it. If the septic tank consists of 2-3 containers, then a long trench is dug so that the distance between them is 1-2 meters.

A trench 0.5 meters wide and about 1 meter deep is dug from the outlet of the sewer pipe to the installation site of the receiving tank. It should be noted that the depth is determined depending on the depth of soil freezing, as well as the height of the receiving flange.

A layer of sand is laid at the bottom of the trench, which is carefully compacted. The correct installation of a septic tank provides for laying pipes at a slope. The lower pointer should be on the receiving flange, the upper one at the exit from the house. 

The pipe should not have elbows more than 30 °, turns at right angles are not allowed. Otherwise, it will clog.

So, for a pipe with a diameter of 50 mm, the slope height should be 30 mm, and for a pipe with a diameter of 160 mm - only 8 mm.

At the bottom of the trench, where the Columbus oh septic tank installation will be installed, a layer of sand and rubble is still poured.

When all the preparatory work is completed, you can start installing the equipment. In order to lower the bulky container into the trench, you will need the help of several people. When installing each container, check its level position. Misalignment to one side can affect the efficiency of the equipment.

When the tanks are installed, pipes can be connected. This must be done carefully in order to prevent depressurization of the system during operation.

After the pipes are connected, lead the wiring and connect it to the electrical part of the system.

If the purified water is planned to be used for irrigation, after the third stage, a storage tank is installed, to which a drainage submersible pump is connected, otherwise, rings without a bottom are placed. Through them, water will go into the ground.

When all the elements of the system are Columbus oh septic tank installation, and it itself has been tested for operability, it remains to sprinkle them with sand and tamp them. Tamping is carried out only by hand, since the use of technology can damage the containers.